DSSS Wireless Conference System TL-RF1



，。

DSSS Wireless Conference System TL-RF1

The GONSIN TL-RF1 DSSS wireless conference system uses worldwide license-free 2.4GHz frequency band and state-of-the-art Direct Sequence Spread Spectrum (DSSS) technology to offer a wireless conferencing solution that combines microphone discussion and video camera tracking.

Features of TL-RF1 DSSS Wireless Conference System
1. This DSSS wireless conference system offers up to 15 selectable channels for audio transmission.
2. It supports up to 254 microphones.
3. Up to 4 simultaneous active microphones are used.
4. There are selectable AUTO or FIFO microphone modes.
5. This DSSS wireless conference system is designed with freely definable code entry for microphone units.
6. It has additional audio inputs for the external microphone system.
7. It offers master outputs for the external sound system.
8. The recording output is good for conference archiving or documentation.
9. The microphones used in this DSSS wireless conference system can be recharged by a single charger or charging case.

TL-RFZ1 DSSS Wireless Central Control Unit

This wireless central unit is the key unit in the DSSS wireless conference system.

Features
1. This wireless central control unit uses a standard 19” rack mountable housing.
2. AUTO or FIFO modes are used for microphone management.
3. The built-in FSC is designed for acoustic feedback prevention.
4. The channel numbers and ID numbers can be preset.
5. The channel grouping used in this wireless central control unit can avoid interference.
6. The maximum system capacity is up to 254 microphones.
7. It has LINE IN for external microphone input.
8. It has REC OUT for audio output to external sound equipment.
9. A RF OUT socket with 13-pin is used for antenna cable connection.
10. 6 x DIP switches are used in this wireless central control unit for setting channel numbers.
11. A 1 x DIP switch is used for setting ID numbers.

Technical Specifications
1. RF modulation: DSSS
2. Frequency range: 2405-2480MHz
3. AC power requirement: 220V, 50Hz
4. Power capacity: 60 watts
5. Frequency response: 50Hz-18kHz
6. S/N ratio: >75dB
7. Dimensions: 423×90×320mm (W×H×D)
8. Weight: 7.6 kg

TL-RFF1 DSSS Wireless Access Point

This wireless access point is the equipment used in the DSSS wireless conference system for accessing signal.

Features
1. This wireless access point offers wireless RF link for all conference units.
2. It is designed for remote mounting on a tripod or wall.
3. It is powered by the central control unit.

Technical Specifications
1. RF modulation: DSSS
2. Frequency range: 2405-2480MHz
3. Transmitting power: 10mW
4. Gain: 5 dBi
5. Mountable on tripod stand
6. Cable connector: 13-pin socket
7. Cable length: 3/5/10/15/20 meters
8. Range: 20x20 meters
9. Dimensions: 225×195×45 mm (W*H*D)
10. Weight: 3.9 kg

TL-RFX1 DSSS Wireless Chairman Unit

This wireless chairman unit is the unit designed for chairman when using the DSSS wireless conference system.

Features
1. This wireless chairman unit is designed for portable tabletop use without cable.
2. The push button is designed to turn the microphone on and off.
3. The MIC button allows the chairman to speak at any time.
4. The priority function enables the chairman to control the conference.
5. The chairman can override all active delegate microphones.
6. A unidirectional electret condenser microphone is used.
7. This wireless chairman unit is designed with a red ring luminant to identify the active microphone.
8. It has a pluggable gooseneck microphone (silver or black optional).
9. It offers a built-in 2W / 8Ω audio speaker with level control.
10. The speaker automatically mutes when MIC is live.
11. It has 3.5 mm jacks for the headphone or recording with level control.
13. The LCD shows unit number, channel number, RF signal, and battery level.
14. The unit address and ID number can be set by up or down buttons.
15. It offers integrated intelligent charging electronics.
16. The built-in USB port allows upgrading firmware if necessary.
17. It offers low battery voltage detection and alarm.

Technical Specifications
1. Backlit LCD: 65x32mm white-on-blue, 128 x 64 dot matrix display
2. Battery type: rechargeable 11.1V Li-ion battery pack
3. Battery volume: 3000mAh
4. Continuous operating time: 20 hours
5. Modulation mode: DSSS
6. Frequency range: 2405-2480MHz
7. Transmit power: 10mW
8. Receiving sensibility: -94dBm
9. Frequency response: 50Hz-18kHz
10. S/N ratio: >95dB
11. Power input: 24V DC
12. Working temperature: 0-50℃
13. Storage temperature: -20-50℃
14. Microphone pick-up range: up to 60cm
15. Microphone stem length: 410 mm
16. Dimensions: 205×140×60 mm (W*H*D)
17. (Optional) 12.6V single charger with connecting cable

TL-RFD1 DSSS Wireless Delegate Unit

This wireless delegate unit is a component of the DSSS wireless conference system.

Features
1. This wireless delegate unit is designed for portable tabletop use without cable.
2. The push button is used for asking to talk and turning microphone on or off.
3. 3 delegate microphones can be activated simultaneously.
4. It has a unidirectional electret condenser microphone.
5. A red ring luminant can be used to identify the active microphone.
6. It has a pluggable gooseneck microphone in silver or black.
7. It has a built-in 2W / 8Ω loudspeaker with level control.
8. The loudspeaker automatically mutes when MIC is live.
9. It offers 3.5 mm jacks for the headphone and recording with level control.
10. The LCD shows unit number, channel number, RF signal, and battery level.
11. The unit address and ID number can be set by up or down buttons.
12. It offers integrated intelligent charging electronics.
13. The built-in USB port allows upgrading firmware when necessary.
14. It offers low battery voltage detection and alarm

Technical Specifications
1. Backlit LCD: 65x32mm white-on-blue, 128 x 64 dot matrix display
2. Battery type: rechargeable 11.1V Li-ion battery pack
3. Battery volume: 3000mAh
4. Continuous operating time: 20 hours
5. Modulation mode: DSSS
6. Frequency range: 2405-2480MHz
7. Transmitting power: 10mW
8. Receiving Sensitivity: -94dBm
9. Frequency response: 50Hz-18kHz
10. S/N ratio: >75dB
11. Power input: 24VDC
12. Working temperature: 0℃-45℃
13. Storage temperature: -20℃-50℃
14. Microphone pick-up range: up to 60 cm
15. Microphone stem length: 410 mm
16. Dimensions: 205×140×60 mm (W*H*D)
17. Charger: (Optional) 12.6V single charger with connecting cable

GX-08 Charging Case

The charging case used in this DSSS wireless conference system is designed for charging this system.

Features
1. It has a rugged, solid-construction case for secure transport and storage solution.
2. Case stacking is allowed by steel knuckled ball corners.
3. The smart charger can hold 8 microphone units with Li-ion battery packs.
4. The external power input socket can connect 15V/7A power adaptor.
5. The charging status for each unit is visible from outside.
6. The trickle charge function is good for keeping batteries in full capacity.
7. Automatic cut-off when full can avoid over charge.
8. The fully charged units may remain in the case.

Technical Specifications
1. Charging time: 8 hours
2. AC power supply: 100-240V, 50/60Hz
3. Power consumption: 105 watts
4. Dimensions: 58x41x51.5 cm (W*D*H)
5. Weight: 13.5 kg

GONSIN is a professional DSSS wireless conference system manufacturer based in China. Apart from wireless conference system, we also offer digital conference system, wireless voting system, video camera system, wireless interpretation system, and more.