Outdoor Light, 4150 Series

Salient Features
Motion Sensor (AUTO) – the outdoor light is designed to turn on automatically when the sensor detects a temperature difference moving across the front of the motion sensor. The light will turn off automatically according to the set time. The ON-TIME control should be set to 1, 5, or 10 minutes and the wall switch should be left at ON mode all the times.
Manual Mode – the decorative motion light can be set to work continuously after dusk for a whole night. Then it will automatically reset to the motion sensing mode.

Specifications
W: 145mm (5-3/4'');
E: 174.5mm (6-7/8'');
H: 418mm (16-1/2'');
Range: up to 30 ft. (9.1 m) (varies with ambient temperature);
Sensing angle: up to 150°;
Sensor aiming adjustment angle: 90°;
Electrical load: up to 100 watt incandescent;
Bulb type: medium base, type ‘A’, 100 watt maximum;
Sensor capacity: up to 500 watt (4.1A) maximum tungsten;
Power: 120 V AC, 60 Hz;
Operating modes: TEST, AUTO, and MANUAL MODE;
ON-timer: 1, 5, 10 minutes;
Test timer: 5 seconds;
Manual mode timer: dusk-to-dawn

Fixture Installation
For best performance, please mount the fixture about 6 feet (1.8 m) above the ground.
1. Remove 2 decorative nuts
2. Remove the mounting plate
3. Tighten mounting screws finger tight
4. Attach the mounting plate to the junction box
This fixture comes with a universal mounting bracket. It is pre-assembled on the fixture to fit the majority of junction box applications.
If the slots on the mounting plate do not fit the junction box screw holes, you can:
1. Remove the fixture mounting screws from the mounting plate
2. Attach the ground wire ‘pigtail’ to the ground screw on the mounting plate
3. Flip the mounting plate over
4. Rotate the mounting plate so the wire path is on the upper right
5. Reinstall the fixture mounting screws and attach the mounting plate to the junction box as shown