Outdoor Light, 4133 Series

Our decorative motion light requires a voltage of 120V AC. Some codes require the light to be installed by qualified electrician. The outdoor light fixture must be properly mounted. For best performance, users are suggested to mount the fixture approximately 8 ft. (2.4 m) above the ground. This lighting system complies with Part 15 of the FCC Rules.

Specifications
Range: Up to 30 ft. (9.1 m) (varies with ambient temperature)
Sensing angle: up to 150°
Electrical load: up to 60 watt incandescent
Bulb type: medium base, type ‘A’, 60 watt maximum
Sensor capacity: up to 500 watt (4.2A) maximum tungsten
Power: 120 V AC, 60 Hz
Operating modes: test, motion activated, manual
Time delay: 1, 5, 10 minutes

2-Year Limited Warranty
This light product is guaranteed to be free of factory defective parts and workmanship for a period of two years from the date of purchase. Purchase receipt is required for all warranty claims.

Installation Notes
1. Remove the mounting bracket
a. Remove the two decorative fixture nuts (CC) from the fixture (A)
b. Remove the mounting bracket (EE) from the fixture (A)

2. Installing the mounting bracket
a. Remove the existing fixture
b. Tighten the two large mounting screws (DD) finger tight into the mounting bracket (EE)
c. Attach the mounting bracket (EE) to the junction box (not included) securely with the two mounting bracket screws (AA)
d. Pull on the mounting bracket (EE) to verify it is securely mounted to the junction box. If necessary, use the screws that were removed from the existing light fixture

3. Changing the mounting bracket orientation
If the slots on the mounting plate (EE) do not fit the junction box screw holes, do as followings:
a. Remove the two large mounting screws (DD) from the mounting plate (EE)
b. Attach the ground wire ‘pigtail’ to the ground screw (1) on the mounting plate (EE)
c. Flip the mounting plate (EE) over
d. Rotate the mounting plate (EE) so the wire path is on the upper right
e. Reinstall the large mounting screws (DD) and attach the mounting plate (EE) to the junction box as shown