PU3500&4500 Industrial Energy Saver

Installation
-Four wires exiting the bottom of the industrial energy saver through a non-metallic connector
-The device can be installed as follows.
1. Use flex conduit and connector to feed the 4 wires (3 red and 1 green) to the panel and connect the 3 red wires to a disconnect box and the green wire to the ground bar;
2. Connect the disconnect box to the electrical system.

-When installing the PU3500 industrial energy saver, use a 30 amp three-pole breaker
-When installing the PU4500 industrial energy saver, use a 40 amp three-pole breaker
-During installation, make sure the power is off until the unit is installed completely, then turn the power on (through the breaker or engage the disconnect box) and check if the light is on.
-If the light is not on, check the breaker, ground and disconnect box for secure connections
-The product will work in a 208/480V environment 50/60 Hz

Benefits
-Reduce electrical noise
-Improve power factor
-Regulate voltage
-Reduce electricity required by existing inductive loads
-Enhance capacity of existing electrical system
-Eliminate danger of harmful power surges on appliances and sensitive electronic equipment
-Reduce harmful effects caused by electrical noise in the electrical system

Features
1. Three-phase
2. Utilizes self-healing low loss capacitors
3. Design life of 20 year
4. Surge suppression: 2000 Joules
5. Typical protection against electrical storms, lightning activity and power utility spikes
6. Let through voltage: 150V line-to-neutral
7. Load rating: 20A, this means the product discharges up to 20 amps at a time
8. Six-way electrical protection
9. EMI / RFI noise reduction 0-40dB
10. Size: 25cm×25.5cm×16cm
11. PU3500 is used for a 200A inductive load, such as a 75hp motor
12. PU4500 is used for a 400A inductive load, such as a 75-300hp motor
13. Both units are in NEMA 3 rated 7'' × 7'' × 8'' enclosures

Cautions
1. Do Not Open. There is risk of electric shock and there are NO serviceable parts
2. Disconnecting the protective earth conductor may impair the performance of this product
3. It is NOT recommended to put any Switches or Fuses in line with the earth conductor.

Related Names
Electrical Energy Saving Device | Power Saving Box | Energy Efficient Products