5 Ton Garbage Truck with Compactor

The 5 ton garbage truck with compactor is developed with a Forland D1780A car body and 1092 rear axle.

Features
1. The compactor can be both manually and electrically controlled from inside or outside the cab with an imported multiport valve.

2. A built-in back pressure valve allows for bidirectional compaction, controlled by hydraulics.

3. Square or round garbage cans can be dumped into the manipulator. A trash hopper is also available.

4. Two 240L square garbage cans can be hung on the 5 ton garbage truck as the feeding device has a large volume for trash.

5. The overturn speed of the manipulator can be easily adjusted with a throttle valve.

6. Two large-volume sewage tanks are installed at the front and back of the 5 ton garbage truck. With the backflow sewage collection device, sewage enters the tanks automatically while a corrosion-resistant rubber seal reduces the chance or leaking during transport.

7. The connection between the carriage and the rear rubbish feeder is sealed with corrosion-resistant rubber to prevent sewage leakage. The self-locking feeder is controlled by hydraulics.

8. The bidirectional hydraulic lock is installed on the lifting system for safe usage.

Technical Parameters of Sanitation Garbage Truck

Note
Truck of 6820mm in length: wheel base: 3400mm
rear overhang: 2200mm
Truck of 6660mm in length: wheel base: 3300mm
rear overhang: 2140mm
The front wall and the front light shall be selected according to the chassis. The engine is YN38CR, YZ4DA3-30 or YZ4DB1-30. The protective device, which is connected to the side and back of the 5 ton garbage truck with compactor by bolt, is made of Q235 carbon structural steel. The sectional dimension of the rectangular tube for back protection is 100mm×100mm, 360mm high from ground.