Concrete Mixer

Concrete Mixer

The forced type concrete mixer manufactured by us consists of stuffbarrel, carrier, motor, decelerator, twirling arm, mixing shovel, etc. Due totwirling arm and shovel is connected by cross assembly and the designs ofworking interval controlled by draw and screw bar, the occasion of mixergetting stuck disappears and the abrasion of shovel greatly lowers. Besidesthat the angle between the shovel and its travel line is obtuse angle both inhorizontal and vertical view, which can greatly improve the effect of mixing.In addition the discharge hole of our machine is set on profile of stuff barreland user can level the barrel so the machine can discharge stuff efficientlyand completely. In term of power, we fix the motor andtransmission mechanism under the mixing barrel and use the cycloidal pin wheel decelerator to control the speedof mixer for security.

Cautions
1.Before starting our concrete mixer, usershould check all parts including bolt, machine oil of decelerator, scraper andpower. When starting the machine, user shouldmake sure the mixing bowl is empty and there is no abnormal sound inside.
2. After the mixer is shut, user should clean themixing bowl when all material discharged off and keep the power cut.  
3. The mixer should be set in a level place and with its wheel axis placed uponlumps of wood to ensure the stable running of mixer.
4. The concrete mixer should be leakage protected at secondary level. Beforethe machine is powered on, user should do the motoring test. Then check therunning of mixing barrel. Normally the empty barrel can run two or threecircles faster than stuffed barrel. If actually it is not so, user shouldadjust the gear ratio.
5. The movement direction of mixing barrel should be the same with arrowindication or user must change the L and N wire. 
6.User should check whether the braker and clutch transmission areflexible and reliable and make sure the pulley and wire are in good condition withnothing barrier nearby.
7. User should often check the inner parts of the concrete mixer.
Make sure the bolt is not loosened and shovels are not bended. When maintainingthe machine, user is advised to pour water with crush stone into mixing barreland start it to clean out the adhered stuff. Then dry off the whole concretemixer

Technical Support
We provide technique support. Any problem, please turn to 24h hotline 86 151-0510-9068(Nicole yang) or email: kebo@tilemachine.com.cn.