Installation of LED Screen

Installation of LED Screen

Part 1. Simple StructureInstallation Guide

1.Wall-mounted Type (Embedded Type)

The wall-mounted installation of the LED screen requires asolid wall or a strong concrete keel inside the wall to assure the screen willremain stable and reliable for a long time. Please make sure the wholestructure is well plotted and installed to assure the outstanding performanceof the whole LED screen.

Steps

1. Plot on the installation wall.

2. Fix the rooting screws and its corresponding joint parts.

3. Mount the frame, aswell as the power-supply, to the wall through joint parts installed in Step 2.

4. Assemble tiles(modules) carefully into the frame by magnets.

Caution: Make sure allfront face of modules are in the same flat surface by adjustingthe magnets.

2.  Wall-supporting Type

The wall-supporting installation of the LEDscreen requires a solid wall or a strong concrete keel inside the wall toassure the screen will remain stable and reliable for a long time. Please makesure the whole structure is well plotted and installed to assure theoutstanding performance of the whole LED screen. This is the same as thewall-mounted installation in Step 1.

Because of the gap between the frame and the wall, the bottom of the frame willlean to the wall.  This necessitates the use of a bearing anchor at thebottom of the frame.

Steps

Same as the Wall-mounted steps above.

3.  Hanging Type

The hanging installationrequires the hanging bar and the whole structure to be solid and strongenough to hang the LED screen for a long time. The back of the screenusually need to be covered.

Steps

1. Plot on theinstallation bar.

2. Fix the rooting screwsand its corresponding joint parts.

3. Mount the frame as wellas the power-supply to the wall through joint parts installed in Step2.  

Caution:Carefullyexamine and make sure the frame is not twisted.

4. Assemble tiles (module)carefully into the frame by magnets.

4.  Sitting Type

The sittinginstallation requires the supporting structure to be solid and strongenough to support the screen for a long time. Please make sure the topface of the supporting structure is flat and even. This type ofinstallation has two different sub-types: a. mobilesitting type where the screen is installed on a movable structure and b. fixedsitting type where the screen is installed on a fixed structure. 

Steps
Same asthe Wall-mounted steps above.

5. Ground Type(Embedded Type)

Groundinstallation requires an even and stable platformto assure the safety and performance of the LED screen. This type usually usesthe rental LED display screen. The screen is usually installed ona concrete floor or a stage.

Steps

1. Plot on the installation place.

2. Fix the bearing anchor.

3. Fix the steel frames bythe bearing anchors.

4. Assemble the modules(tiles) into the steel frames.

Part2. CabinetStructure Installation Guide

There are four types ofinstallation as shown below:

1. Ground-supporttype

2. One-polesupport type

3. Roof support type

4. Wall-mounted (embedded) type

All cabinet structureinstallations have similar structures and similar installation requirements asshown below:

1. Allow at least 600SQM maintenance space for every4~5 layers of cabinets for installation andmaintenance

2. Ladders are required between each neighboringmaintenance space.

3. Lights should be installedat every maintenance space.

4. Ascertain the 40mm*40mmsteel plate to be installed in the identical surface

5. Assemble the cabinets withdowel pins, screws and joint parts carefully andprecisely, making sure the cabinets are tight and even.