F0318 5x7 Inch LED Headlight

5 x 7" square LED head light
Operating Voltage: 10-30V DC
Waterproof rate: IP 67
1800Lms@20W on low Beam
3700Lms@35W on high Beam
180Lms@3W on DRL
Color: chrome reflector
Color Temperature: 6000K
Material: Die cast aluminum housing
Lens material: PC 30,000+ hour service life
Dimensions (cm): 19.9 x 14.1 x 8.1cm
Certificates: CE, RoHS, IP67

Key Applications
1984-1988 Fiero 1987-1995 Jeep Wrangler YJ Trucks with 5.75 x 7inch sealed beam installation hole Old cars with 5.75 x 7inch sealed beam installation hole


Design drawing
Features

Life time: Less than 5% lumens depreciation, even at 30,000 hours
Higher light efficiency by dual side-emitting
Body: black
UV-resistant and hard-coated PC lens
Never need to replace a bulb
Built in “Error-canceller"
Plug & play replacements Universal under DC9V-DC32V
IP67

Benefits

High brightness
Best CUT-OFFLINE with broad light-spread
Excellent pure white light output
Long life-span up to 30,000 hours
High reliability

Electronic Parameters

These parameters are tested under 25℃, 10 minutes after lighting

Parameters of input

Function	Current Under 12V(A)	Power Under 12V(A)	Current Under 24V(A)	Power Under 24V(W)	Current Under 30V(A)	Power Under 30V(W)
Front position	0.12	1.44	0.06	1.44	0.05	1.44
Low Beam	1.33	15.96	0.67	16.08	0.54	16.08
High Beam	2.56	30.72	1.26	30.24	1.03	30.24

Parameters of output

Function	CURRENT(A)	VOLTAGE(V)	POWER(W)	P.F (%)
Front position	0.18	6.58	1.2	82.25
Low Beam	2.17	6.46	14.0	87.83
High Beam	4.13	6.46	26.7	86.85

Uses standard H4, 3-blade wiring connector.
Come with H4 to H13 converter
9V-33V Multi-volt design works with both 12V and 24V systems
Operating temperature range: -40˚C to 60˚C
Over-voltage protection to 600V
Constant Power Output

Optics Parameters Low Beam


Height of Lamp Fixed: H = 1.00m
Illumination Area : L = 200.0 m, W = 20.0 m
Voltage: 12.800V Current: 3.45A
Power: 44.16W

High Beam


Height of Lamp Fixed: H = 1.00m
Illumination Area): L = 200.0 m, W = 20.0 m
Voltage: 12.800V
Current: 3.45A
Power: 44.16W

Installation Steps

A. An error-canceller is already built into the headlights. If the light flickers after installation in the vehicle, a resistor wire might be needed.
B. If you use this headlight to replace a motorcycle lamp, a motorcycle bracket may be needed if the light does not fit with the original brackets.
C. If the original plug in the car is H13, a converter may be needed. Please locate the converter in the bottom of the packaging container.

Removal of shade Exposed light body Removal of decorative plate Removal of fixed bracket Pull out H4 plug Installation effect

Related Products
vehicle headlamp, automotive LED light