Submersible Water Pump 4LL

Send Message Request a Quote

Submersible Water Pump 4LL

SAP Series

It’s important to note, before installing the submersible water pump 4LL verify that all pipes (iron, plastic or rubber) are clean inside to avoid any obstruction to the ejector nozzle. At the foot of the ejector must be installed a foot valve or a check valve, once the pump is installed, fill completely both pipe and pump body with clean water. To preserve an efficient priming process of the submersible water pump 4LL it’s necessary a certain pressure in the circuit, therefore it’s recommended to install a membrane tank as soon as the pump is delivered.

Performance Range of Submersible Water Pump 4LL

Suction lift down to 45m
Flow rate up to 3600l/h

Technical Data of Submersible Water Pump 4LL

Pump Model		DNP	DN1	DN2	DN3	DE
Single Phase	Three Phase	DNP	DN1	DN2	DN3	DE
SAP70	SAPt70	4"	1 1/4"	1"	1"	96
SAP85	SAPt85	4"	1 1/4"	1"	1"	96
SAP150	SAPt150	4"	1 1/4"	1"	1"	96
SAP100	SAPt100	4"	1 1/4"	1"	1"	96

Pump Model		Power		HS M	Flow Rate Litres/Hour
Pump Model		Power				120	240	360	480		600	720	840	960	1080	1200
Single Phase	Three Phase	HP	KW		Total Dynamic Head In Meters
SAP70-4"	SAPt70-4"	0.5	0.7	15	46	42	37	34	30	28		25	22	19	17
SAP85-4"	SAPt85-4"	0.6	0.85		50	46	42	39	35	32		30	27	24	21	19
SAP100-4"	SAPt100-4"	0.75	1		54	50	46	43	39	36		34	31	28	25	23
SAP150-4"	SAPt150-4"	1.1	1.5		85	78	74	70	66	61		57	53	48	44	40
SAP70-4"	SAPt70-4"	0.5	0.7	20	34	29	24	21	18	16		13	11
SAP85-4"	SAPt85-4"	0.6	0.85		38	33	29	26	23	21		18	16	14
SAP100-4"	SAPt100-4"	0.75	1		40	35	31	28	25	23		20	18	16